Break out the handmade lanyards — it's festival time again.
Knitting a long 3-stitch i-cord is a fast and easy way to make lanyards that are soft and comfortable to wear. These won't cut into your skin or feel scratchy like standard ribbon lanyards or lanyards with breakaway clasps. You can customize your lanyard by using any colors you desire and even add beads or other findings for a truly unique piece that suits you.
I used worsted weight yarn and size 6 DPNs to make the lanyards in the photo, but they can be made with any yarn weight and needles that give you a nice, snug gauge on the i-cord. Leave a 6-inch tail at each end of your work so you have plenty of length to secure the hardware and fasten with knots before weaving in the ends.
I'm thinking a nice fingering weight yarn on size 1 needles with lots of sparkly seed beads would make a lovely one. I'm going to have to try that next.
These work up quickly. I made the worsted weight ones approximately 36-38 inches long, and they each took just about an hour to knit. (Adding beads would, of course, make the knitting time significantly longer.) At this gauge my lanyards each used about 12.5 yards of yarn. After fastening off and securing the hardware with a few knots and weaving in the ends, I'd estimate each lanyard takes about 90 minutes to complete. And you could easily sell these for about $10 each, depending on your audience, so ... not a bad ROI.
Before tying the ends together add a small keychain split ring or a large jump ring and a spring-close clip or lobster clasp. Tie the ends together over the split ring/jump ring and weave the ends back through the i-cord. Simple, easy finish.