My first machine-knit infinity scarf / cowl

I’m so excited! After lurking for months on various machine knitting Facebook groups and absorbing lots of helpful wisdom and tips, I finally took the plunge and bought my first knitting machine, a Sentro 40. 

I selected the 40-pin machine as my entry point into the machine knitting world because it was affordably priced, and I think its size is a good compromise between the biggest machines and the tiny machines. I’m also glad I spent months studying the experiences of others via the Facebook groups and also YouTube because that knowledge made it possible for me to hit the ground running (or if not running then at least walking) rather than to have to stumble through the learning curve that these machines invariably have.

My Sentro arrived yesterday, so as soon as I got off from work I assembled the pieces (i.e., put the legs on) and started cranking through one of the little sample balls of yarn that came with it. I already knew the trick for how to cast on because of my earlier research. 😊 On that first run-through I wasn’t paying attention to whether stitches were dropping (many of them did); I was just trying it out and having fun.

 

This infinity scarf (or cowl if worn double-wrapped) is the second thing I did with my Sentro. I cast on with the gray yarn, but I decided later that it would have been smarter to have cast on with waste yarn because that would give a neater starting edge. Mental note for next time. 😉 Jojo Juju (one of the goddesses of machine knitting on YouTube) recommends about 4-6 rows of waste yarn at the beginning and end of most projects. 

I was a lot more careful about watching for dropped stitches this time. I don’t have enough experience yet to say for sure whether the Sentro was dropping so many stitches because of the yarn I was using, or because of the way I was cranking it (my tension or whatever), or because that’s just a quirk of the Sentro. Time will tell. But even having to stop several times on just about every row to pick up dropped stitches (this video shows one method for how to correct it), it literally took less than two hours of work TOTAL from start to finish to whip out this entire project, which used all of a 315-yard skein of Caron Simply Soft. TWO. HOURS. Including the finishing work. These machines are basically miraculous.

I finished and joined the edges with the faux turban twist knot join used in all those trendy turban head-wrap patterns, like this one. The full skein of yarn yielded a tubular scarf that’s about 6 inches wide (laid flat) by about 60 inches long. I didn’t count how many rows that is (the 40-pin Sentro doesn't come with a row counter); I just used the full skein of yarn.

Which brings me to another, much more personal point about why I wanted to try working with a knitting machine: Chronic joint pain in my hands and arms has gotten bad enough over time that it has become nearly impossible for me to finish any yarncraft projects anymore. I would start a project, work on it for a couple of days, and then have to set it aside for several weeks while I waited for my hands and arms to recover before I could even think about continuing. As you can imagine, this makes for really slow going. But I think having a tool like this knitting machine will make it possible for me to keep creating, which is what I want to do, despite my disability.